Dynatech MP-5000 Servisní příručka stáhnout pdf (Strana 61)

Service Manual Repair Procedures 57

3. Spread the casing open to an angle of about 80 degrees.

4. Detach the following cables from the front chassis (indicated in figure below):

• Cable to P5 on the Analog board, from the left side panel ECG connector on the

rear chassis.

• Cable to P6 on the Analog board, from the left side panel IPB connector on the

rear chassis.

• Cable to P7 on the Analog board, from the left side panel temperature jack on the

rear chassis.

• Cable to P8 on the lower (Digital) board, from the right side panel on the rear

chassis.

• Cable to P9 on the Digital board, from the right side panel on the rear chassis.

DISCONNECT 2

UNDERLYING

DIGITAL BOARD

DISCONNECT

3 CABLES

CABLES FROM

1 2 ... 56 57 58 59 60 61 62 63 64 65 66 ... 129 130

Žádné komentáře

Dynatech MP-5000 Servisní příručka Strana 61