Dynatech MP-7000 Servisní příručka Strana 64

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 92
  • Tabulka s obsahem
  • ŘEŠENÍ PROBLÉMŮ
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 63
60 9650-0801-01 Rev. A
3 Disconnect multi-wire IBP cable with ferrite
in the area illustrated.
4 Cut the tie wrap to the IBP cable in the area
shown with the orange stick.
Note: During reassembly, secure a new tie
wrap to the IBP cable.
5 Disconnect the USB flex cable from ZIF
connector in the area illustrated.
6 Lay front end of separated unit down with
opened side facing up.
7 Disconnect the black EtCO
2
tube
connector from the air vent.
8 Remove four (4) screws in the areas
illustrated to release the silver EtCO
2
module.
Note: During reassembly, torque screws to
6 in-lbs.
multi-wire IBP cable
Zobrazit stránku 63
1 2 ... 59 60 61 62 63 64 65 66 67 68 69 ... 91 92

Komentáře k této Příručce

Žádné komentáře